FstaRockr Burns
Regular Contributor
Hi all - busy trying to get the stbd motor to run smooth. cleaned carb out last week.. no vac leaks far as I can tell.. when i connect a timing light each wire gives a perfect flash - no hiccups..
I noticed while replacing the solenoid a yellow resin running down from the electronic "gizmo" at the rear of the motor (There is a standard coil next to the dizzy) - so im not sure what this thing does?
Will an open gap spark test of about 7/16 show any issues? Is this thing possibly bypassed?
it looks like this:
Is there a way to test these things? Im gonna swap out the port engine one and see if it runs any better as the port motor is smooth smooth..
thanks
I noticed while replacing the solenoid a yellow resin running down from the electronic "gizmo" at the rear of the motor (There is a standard coil next to the dizzy) - so im not sure what this thing does?
Will an open gap spark test of about 7/16 show any issues? Is this thing possibly bypassed?
it looks like this:
Is there a way to test these things? Im gonna swap out the port engine one and see if it runs any better as the port motor is smooth smooth..
thanks