"Just put seal kit in my 1987
"Just put seal kit in my 1987 48hp evinrude lower unit, when i was putting seals in rear bearing housing i noticed seals were close to the needle roller bearing, looked like the bearing was not seated so i tapped it on down to the bottom where it looked like a seat, know i`m second quessing myself, can you seat the bearing down to far and off the race? any advice anyone?"
"Just put seal kit in my 1987 48hp evinrude lower unit, when i was putting seals in rear bearing housing i noticed seals were close to the needle roller bearing, looked like the bearing was not seated so i tapped it on down to the bottom where it looked like a seat, know i`m second quessing myself, can you seat the bearing down to far and off the race? any advice anyone?"