Logo
FULL SITE MENU

AQ120B INTERMEDIATE SHAFT BEARING

"Yes, IMO. The item is the pil

"Yes, IMO. The item is the pilot bearing which supports the stub shaft inside the housing and driving the Ujoint, right?"
 
YES CAN I LEAVE THE BELL HOUSI

YES CAN I LEAVE THE BELL HOUSING IN THE BOAT OR DO I HAVE TO TAKE IT OUT TO INSTALL THE NEW BEARING
 
"As I said, "yes, IMO"

"As I said, "yes, IMO". I DON'T KNOW OF ANY OTHER WAY but somebody else is welcome to chime in, as always."
 
"The bearing that I think you

"The bearing that I think you are talkin about is in the flywheel on the engine.....Unfotunately, there is no other way to change this, except pulling the engine.
Is it making a noise?"
 
"Eric, the bearing in the flyw

"Eric, the bearing in the flywheel does not turn. It is there just to support and center the primary shaft, but its inner and outer races do not turn relative to each other. Therefore, I don't think it can make any growling noise or anything of the sort.
wink.gif


Back to the original question, you may be able to remove the engine and leave the bellhousing attached to the transom shield, but it it is far easier (and faster) to pull engine and bellhousing together."
 
Back
Top