Logo
FULL SITE MENU

95 1967 evinrude

W

wd40

Member
I have a 1967 9.5 hp evinrude

I have a 1967 9.5 hp evinrude I installed new points and carb kit also cleaned reed valves check fuel pump the compression is 70 lb. both clinders the motor runs ok with the cover off when i put cover on it loads up I made sure foam is not in the way actually removed some of it think I have checked every thing please help
 
"the compression is very very

"the compression is very very very low, is there any reason why you can't run with the cover off ?"
 
what should the compression be

what should the compression be or acceptable compression.It just bothers me that I can't figure it out.
 
Those had a rubber bellows for

Those had a rubber bellows for an exhaust from the exhaust casting to the outside clam shell. They would burn up with a water pump failure and that might also explain you weak compression.
 
"ur cowling prob,is exhaust,in

"ur cowling prob,is exhaust,into pwrhd area...extremely common on those,as well as bad mtr mnts,..or weak."
 
"comp is not bad,on that eng,f

"comp is not bad,on that eng,for the yrs..keep messing w/it and u will like it...dont even think,about putting in a boat shop,they wont touch it...i ,..do,however....a few yrs ltr,and u'd be better off,tho."
 
Back
Top