Logo
FULL SITE MENU

93 150 LOOPER QUESTION ABOUT PACK

P

PAT OWEN

Guest
"CAN A FAULTY POWER PACK CAUSE

"CAN A FAULTY POWER PACK CAUSE A WEAK SPARK ON
JUST ONE PLUG ?? I MOVED AROUND THE COILS,
NO CHANGE. NEW WIRES ALSO. JUST ONE PLUG LOOKS
A LITTLE BLACKISH AND SLIGHTLY WETTER THAN ALL THE
OTHERS. "LOWER PORT". ALL OTHER PLUGS RUNNING
SLIGHTLY TAN, ALMOST TOO CLEAN SOMETIMES.
RUNNING PRE MIX. HAVE NOT CHECKED COMPRESSION YET.
MOTOR RUNS FINE, BUT I'D SWEAR I COULD HEAR ONE
CYL NOT MAKING GOOD POWER AT CRUISE.
THANK YOU FOR ANY IDEAS....HOUTEX"
 
Power pack works or do not wor

Power pack works or do not work -light bulb principle!
Your problem is probably either a carburetor problem or bad cylinder.
 
"Note.... Typing in all CAPS m

"Note.... Typing in all CAPS makes for difficult reading.

Remove the spark plugs, carefully noting what cylinder they were removed from, and describing their condition/color ie......

1 = Brown Dry
2 = Brown Dry
3 = Black Fluffy Looking
4 = White Wet
Etc etc.... Whatever engine you have, 4cyl, 6cyl, etc.

This might lead to indicating what the cause of the problem is."
 
I didnt find my Power pak comp

I didnt find my Power pak completely bad.
It just wont signal #2 plug to spark. if i flip flop the #2-#3 sensor wires on the input side of the pack then #3 igniton goes quiet. the pack doesnt send the signal to the output side of the #2 position on the pak. The result is the same. New Powerpak.
 
Back
Top