76 evinrude ob

[usmcramsey]

how to adj the shift and thort

how to adj the shift and thorttle cable on this
unit? 1976 evinrude ob 115hp.

 

[joereeves]

"(Centering Shift Cable&#4

"(Centering Shift Cable)
(J. Reeves)

When all is as it should be, the proper method to adjust the shift cable is to disconnect the cable from the engine. Move the shift linkage on the engine to find the center of the play in neutral, and when found, leave it centered.

Now, grab the end of the shift cable sleeve, push and pull it to find the center of the play there, and center that play.

Adjust the trunion on the threaded portion of the shift cable so that the centered play of the cable lines up with the centered play of the engine's shift linkage. Install and lock the shift cable with the retaining clamp in that position. That's it.

When time permits, visit my store at: http://stores.ebay.com/Evinrude-Johnson-Outboard-Parts-etc?refid=store

Throttle cable.... Adjust it so thast the idle rpm is where it should be. On a flushette (gaeden hose), the idle rpm should be as follows:

20" shaft: 1000 rpm

25" shaft: 1200 rpm"