S/N 3480000. Compression 105 psi both cylinders. Stator coils: High 182 ohms; Low 4780 ohms: Ignition coils: Primary 0.4 ohms; Secondary + or - to tower no reading(Spec 800-1100 ohms), + or - and tower to ground 563 ohms. Installed new points and condenser. Good blue spark across 3/8" gap. Ran great for 10 mins in tank, then died.....no spark at either cylinder. Questions: 1. How can I test the ignition module 336-4516A2? 2. Why no reading on ignition coil secondary? Any help is greatly appreciated. Thanks. Jerry
Home
Outboard Motor Parts
Chrysler outboard parts Evinrude outboard parts Force outboard parts Honda outboard parts Johnson outboard parts Mariner outboard parts Mercury outboard parts Suzuki outboard parts Tohatsu outboard parts Yamaha outboard partsInboard & Sterndrive Engine Parts
Chrysler Marine inboard parts Crusader Marine parts MerCruiser sterndrive parts OMC sterndrive parts Pleasurecraft Marine parts Volvo Penta marine parts + MoreAll Engine Brands
All Manuals HomeOutboard Repair Manuals
Chrysler outboard manuals Evinrude outboard manuals Force outboard manuals Honda outboard manuals Johnson outboard manuals Mariner outboard manualsMercury outboard manuals Nissan outboard manuals Suzuki outboard manuals Tohatsu outboard manuals Yamaha outboard manuals
Inboard & Sterndrive Engine Manuals
MerCruiser sterndrive manuals OMC sterndrive manuals Volvo Penta marine engine manualsPlease Note
MarineEngine.com does not offer troubleshooting assistance or repair advice by email or by telephone.
You are invited to join our public Boat Repair Forum to seek assistance from other members.
You may also visit the Boat Motor Manuals section of our site to obtain a service manual.