65 Hp Electric sift again

[Aussie outboard]

Got the leg off, Put Soap around rear shaft seal and top drive shaft seal. Put some air in the top vent. Shaft move up but no leaks, I don't have pressure tester to see if it holds but no leaks when I applied air??? Now the big ? When you take out 4 bolts on solenoid cover does the unit lift out??

 

[racerone]

Remove the 4 bolts and the 2 solenoids lift out as an assembly.

 

[Boobie]

If a solenoid seems stuck, just don't TUG on the wires.

 

[Aussie outboard]

Ok, Got the Old Solenoid unit out and have a New unit to put in, My question is where do you put the excess wire's Green and Blue under the cover??/ Also someone said to clean the Oil screen?? where is it?? Thanks In advance

 

[racerone]

Oil screen is way down inside the gearcase and in front of the oil pump.-------Requires complete dis-assembly to inspect it.

 

[Boobie]

Have you got a model #

 

[Aussie outboard]

Oil screen is way down inside the gearcase and in front of the oil pump.-------Requires complete dis-assembly to inspect it.

No Worries, What about the wires?? Just Fold them into the cavity??

 

[Aussie outboard]

I will get the Model Number and post it. it is 1972 65 Triumph Evinrude

 

[Boobie]

If you have excess wires below the cover just fold them into the cavity.

 

[Aussie outboard]

If you have excess wires below the cover just fold them into the cavity.

Thanks, Is there anything else I need to do while I got the unit out?? I have changed the Oil Type C, Cleaned everything best as possible. I saw a small port inside the cover, should I spray some carbie cleaner thru the port?? r just bolt it back together. Thanks a Million for the help

 

[Aussie outboard]

Remove the 4 bolts and the 2 solenoids lift out as an assembly.

Thanks to everyone who responded, I go it back together today and everything works. Thanks for the advise. Regards from Paul