My 6 hp trolling motor has not run for 6 months ,it worked well when last used,it was not run dry after last use,
After many attempts I finally got it started but find that after 30 sec or so when the choke is pushed in it stops,if I pull the choke out before it stops it picks up revs and runs for about 30 sec before stopping.
It will start again on full choke but will not run longer than 30 sec.
Could some one please point me in the right direction.
After many attempts I finally got it started but find that after 30 sec or so when the choke is pushed in it stops,if I pull the choke out before it stops it picks up revs and runs for about 30 sec before stopping.
It will start again on full choke but will not run longer than 30 sec.
Could some one please point me in the right direction.
Last edited:
