"I have a 1995 SR 290 that had
"I have a 1995 SR 290 that had a 454 installed. Bought a slightly used 2004 496Mag and installed it (after a few issues). I hooked the existing charging harness up for the key switch and accessory power functions. Then I bought a Systemview and Smartcraft guages and hooked up throught th 10Pin CAN harness. The engine starts but as soon as it warms up, the relays on the top of the ECM start clicking and the engine stumbles every 10 seconds. No fault codes, fule pressure is solid, no water or contaminates in fuel, voltage is 14.
Any Ideas??
George
Also - where the heck do you plug in the fuel sender???"
"I have a 1995 SR 290 that had a 454 installed. Bought a slightly used 2004 496Mag and installed it (after a few issues). I hooked the existing charging harness up for the key switch and accessory power functions. Then I bought a Systemview and Smartcraft guages and hooked up throught th 10Pin CAN harness. The engine starts but as soon as it warms up, the relays on the top of the ECM start clicking and the engine stumbles every 10 seconds. No fault codes, fule pressure is solid, no water or contaminates in fuel, voltage is 14.
Any Ideas??
George
Also - where the heck do you plug in the fuel sender???"