"I hope someone can help as I
"I hope someone can help as I am trying to get some information as to what could be going on with my port engine. I had two new Crusader 5.7 MPI's installed in the fall of 2006. I have less than 100 hours on them now. They ran flawlessly for the first 25 hours or so until I pushed both engines up to around 4900 rpm's for about 15 seconds (still not quite full throttle)just to open her up some, and then back down to cruising speed at around 4200 rpm's. It was less than a minute later when the port engine by itself increased in speed up to around 4600 rpm's and then down to 3800, and back up again to around 4200. This went on back and forth for about 4 minutes before leveling out. I thought it was a fluke until I took it out on subsequent trips and at any random time I would notice a surge in rpms again with port engine for a few seconds. Some times it surges up and then again it drops in rpms. The starboard engine has never done this and continues to run perfectly. My dealer is getting the program so that they can hook the engine up to the computer and see if there any codes. Has anybody seen this happen before, and if so, what was the problem? Thank you very much."
"I hope someone can help as I am trying to get some information as to what could be going on with my port engine. I had two new Crusader 5.7 MPI's installed in the fall of 2006. I have less than 100 hours on them now. They ran flawlessly for the first 25 hours or so until I pushed both engines up to around 4900 rpm's for about 15 seconds (still not quite full throttle)just to open her up some, and then back down to cruising speed at around 4200 rpm's. It was less than a minute later when the port engine by itself increased in speed up to around 4600 rpm's and then down to 3800, and back up again to around 4200. This went on back and forth for about 4 minutes before leveling out. I thought it was a fluke until I took it out on subsequent trips and at any random time I would notice a surge in rpms again with port engine for a few seconds. Some times it surges up and then again it drops in rpms. The starboard engine has never done this and continues to run perfectly. My dealer is getting the program so that they can hook the engine up to the computer and see if there any codes. Has anybody seen this happen before, and if so, what was the problem? Thank you very much."

