Logo

2002 8.1 L GSI won’t start

Beaverlake Bay

New member
Was running fine when we put it away for the winter and a garage. It started up for a very short time and then quit. We put in a new crank case position sensor and a new fuel filter which we primed, but that did not help we also check the Starting lanyard by the steering wheel to make sure that wasn’t a problem. It’s OK.

Any ideas?

Thanks!
 
Check the fuses on the engine by physically pulling them out and inspecting them.. that mentioned, it may be a ignition relay sticking internally.. try tapping on the relays lightly while the key is on…

Do the gauges power up?

Also should have some fuses at or under/behind the dash area or even possibly a single circuit breaker button to push by the ignition key.
 
Pretty sure that uses the MEFI-4 ECU....search the www and find the MEFI-4 manual - it has all the basic diagnostic procedures in it...
 
Back
Top