1998 twin 150 ocean runners

[zackfactor]

I have twin 150 ocean runners

I have twin 150 ocean runners on a 25 foot mako i just bought. they have 200 hrs on them and have been sitting for 5 years.cleaned the carbs and when i did so i did not put kits in them hoping that they would be ok. when i put fuel to them it comes out of the tom of the fuel pump and also out of the jet in the middle of the intake.i assume i need to put kits in them but what about the fuel pumps? is there a gasket that goes in where the float is? any info would be greatly appreciated. i know they are good motors but i have never messed with them. thanks for the help.

Also if anyone knows of a good graphics shop in the southwest florida area i need some work dont there too.

 

[jwbmarine]

"yes,u need to install kits..s

"yes,u need to install kits..set floats exactly level w/carb bowl,when upside down..make sure,..high speed jets are absolutely clean/clear.u can use any de-carb solution..do not use carb cleaner.there is a rebuild kit avail for the fuel pumps (oms Pumps).u can look up parts at shop.evinrude.com ,u may can get the o rings (that i suspect are leaking on top of pump at tube)by themselves,..do not use a reg o ring."

 

[zackfactor]

thanks

thanks