Logo
FULL SITE MENU

1995 Merc 75HP

ibnfshn

ibnfshn

Advanced Contributor
"I did a link & sync with

"I did a link & sync with no problem except figuring out where to make the final idle speed adjustment. Usually its pretty obvious but I'm drawing a blank on this one. I can id the full throttle stop screw, Idle timing screw, WOT timing screw and throttle cam adjustment screw. Where in the world do you make the final idle adjustment?"
 
"From the service manual.

I

"From the service manual.

IDLE ADJUSTMENT

With engine in water, connect electrical harness and fuel line to engine. Start engine and allow to warm up.

Shift into “Forward” gear and adjust carburetor low speed mixture screws properly (refer to “Carburetor” section)

Holding throttle arm at idle position, adjust
idle timing screw to attain an engine
idle RPM of 650-700 RPM in “Forward” gear.

Tighten locknut and turn off engine."
 
I can email you the section in

I can email you the section including the diagrams if that doesn't help...
 
"I think JB was getting jealou

"I think JB was getting jealous because I am so good lookin'
lol.gif


So put my motors up instead - have to show the Canadian colours eh!"
 
Thanks Graham. I need to get r

Thanks Graham. I need to get rid of this Seloc manual and get the factory one.
 
I like the Selocs for all the

I like the Selocs for all the (notes) and "good words" - but I use it in combination with the service manual which is just awesome in it's step by step detail...
 
"If this is your "personal

"If this is your "personal" motor, I can help you out with a service manual for it. Drop me an email. I have most of them on the computer...."
 
Back
Top