hydrohellion
New member
Hi, I am looking at getting an evinrude 200XP with a blown power head. the rod went through the side of the block, and it is missing a head.
Just wondering where to get the parts i need to build this up and if it is really worth fixing it.
Is it possible to weld the block and sleeve the piston??
I am a student on a budget but am very mechanically inclined. I have access to a full machine shop and know how to use all the machines including cnc and wire edm machines.
I have a lot of experience with motorcycles and 2 strokes, but have never done a boat motor before (other than RC) any tips or advice would be greatly appreciated.
thanks
Kev
Just wondering where to get the parts i need to build this up and if it is really worth fixing it.
Is it possible to weld the block and sleeve the piston??
I am a student on a budget but am very mechanically inclined. I have access to a full machine shop and know how to use all the machines including cnc and wire edm machines.
I have a lot of experience with motorcycles and 2 strokes, but have never done a boat motor before (other than RC) any tips or advice would be greatly appreciated.
thanks
Kev