New problem. My "repair" or the tilt assembly something went wrong. On this motor to adjust trim you Push in the knob and rotate the tilt trim assembly It was working "sort when I first got the motor (it broke which caused this odessey) However now the shallow drive # 29 is in the way I cannot push in to rotate. I am certain I've put thing back the right way, No idea what is going on. Am supposed to lift the motor out of the way then rotate and then drop the motor down? Not too convienant
Any ideas?
Here is my previous thread.
prob going to be on the water on Sat or Sun.
http://www.marineengine.com/boat-fo...-anniversary-)-9-5-Evinrude-Johnson-out-board
Any ideas?
Here is my previous thread.
prob going to be on the water on Sat or Sun.
http://www.marineengine.com/boat-fo...-anniversary-)-9-5-Evinrude-Johnson-out-board
Last edited: