1965 Evinrude seal replacement?

[Aaron Breen]

Okay i just got this 1965 5hp Evinrude Angler and i would like to replace the seal seal that seperates the water pump from the lower gear case. Question is how do i get it out? Do i just use a flat head and pry or does is there a special tool? For reference it is number 20 on this parts diagram:Evinrude Gearcase Group Parts for 1965 5hp 5502 Outboard Motor

Thanks

 

[joereeves]

There is a special tool for that seal removal but..............

The prying method will do it BUT one must be extremely careful not to chip, break, or damage in any way the surrounding aluminum castings. You can also use a small slide hammer setup that has a hook to grab the underside of the seal.