matramurena
New member
I have a '63 Evinrude 3302 3hp engine that I am restoring after years of storage. Condition was unknown, so that is always a gamble...
After cleaning the carb and fuel line (these was totally clogged) I managed to start up the old b@stard. Even with the old plugs (J6J, no longer available) she runs quite nicely actually. However I am wondering about cooling. The head does not get all that hot so I am hoping that all is well here, but there is no control tell-tale as far as I can see...
Is there a way to check for flow inside the engine? I do not see any cooling water coming out of the engine at all...
After cleaning the carb and fuel line (these was totally clogged) I managed to start up the old b@stard. Even with the old plugs (J6J, no longer available) she runs quite nicely actually. However I am wondering about cooling. The head does not get all that hot so I am hoping that all is well here, but there is no control tell-tale as far as I can see...
Is there a way to check for flow inside the engine? I do not see any cooling water coming out of the engine at all...