Logo
FULL SITE MENU

15hp Evinrude Starts & Dies?

Joe is still with us, thanks Joe. Right.....could it be flooding out??? How hard are you sqeezing the bulb in order to get the gas mix to run out?
 
If normal pressure is producing the fuel flow out front of carb, perhaps we are flooding out. Joe might be right. Then it becomes hard start, especially with the extremely slow speed allowed when in neutral. That should be a simple fix then, brah. Float or needle or seat.
 
sorry for late update,
I think I found an issue.
the Nut which hold the Flywheel is stripped and not holding down the flywheel. measured the pitch on the shaft and I got a pitch of 1.5 when I bought a M14x1.5 it did not work.
does anyone know the exact specs on the Nut for Flywheel?
I found the Nut on Various parts sites but they want like $17. if I know exact specs I can get for Tacoma Screw for 2 dollars probably.
I gave them my old one but it was to gone to get a accurate pitch reading.
 
So how does the key and channels/grooves/slots look? If it is sloppy enough to interrupt spark, then you have to deal with that too. Might need to dress the crankshaft with a die also. I will check size on a 15 out in my shop.
 
Last edited:
the woodruf key looks sloppy . i am getting a new one today. also found the exact measurement for the Nut M22 2.5mm pitch. the threads on crank are fine, looks great, it is the threads on the Nut
 
That size doesn't sound right, however. I am going out to the shop now.....okay......cold out there. 6 degrees with 30 mph winds. 9/16" 18 threads per inch, brother. That is made in USA, so is the nut you need. Checked it on a crankshaft out of a 15 hp. It is exactly the same. 9/16 is only 14.2875mm. Your 22 is almost a 7/8"....no way.......did you say it was a 15 hp or a 50 hp???
 
Last edited:
If it is a crankshaft seal leak, we should see smoke coming from under the powerhead, correct? I encountered the same prob with my old 15hp Evinrude. Replaced fuel pump (bladder type) with another (second hand) one, same problem. It could be that i replaced a faulty fuelpump with a faulty fuelpump, just to prove to myself I'm only a stupid human.
 
??--Why would a leaking seal produce smoke under the powerhead here?-----The exhaust exits under the power head.----Being a 2 stroke you would see smoke !
 
well i wonder where else that smoke comes from, but it's definitely happening right under the power head. Gotta check entire exhaust pipe. While I'm at it, I'll see if I can improve it to get more of the 'expansion' effect. Which gave much of the difference between the Johnson 9.9 and Evinrude 15hp. Now boiling my carb, hoping that'll be the answer on why it only runs 4 seconds max.
 
Apexmaster34 said:
I have a 89 15hp w electric start out hard.
i have rebuild carb with a kit all new comp. New plugs , wire,
New fuel filter.
Engine starts ,runs for about 5sec then dies.
I have checked everything over and over . When I hot starter I see fuel flowing to carb while cranking, so there is fuel
Also test for spark with spark tester and I have really strong spark
What could it??
Thank you
Click to expand...
Air fuel mix. My evenrude needs choke reduced in apx 5 seconds or it dies.
 
Back
Top