Logo
FULL SITE MENU

Search results

  1. S

    2012 Crusader 602C exhaust configuration

    Thanks. Yes the top one is also an anode, looks like an E-0. No label on the heat exchanger but it is in the owner's manual. Unfortunately, they don't list the part #s in the owner's manual. I stopped by my local marine parts store (not a chain) to look for the big anode. They had some Crusader...
  2. S

    2012 Crusader 602C exhaust configuration

    I've only found 1 anode so far. Instead of a 2nd water inlet, there is a giant anode in that spot. I have to figure out what size it is. Edit: It appears to be an E-3A anode 3/4"x3/4". The next size up is 2" long which can't fit in that location. 20250727_193708[/...
  3. S

    2012 Crusader 602C exhaust configuration

    I had a pair of 454XLs for 14 years & replaced the exhaust elbows regularly so I was familiar with that. These are different though, or least they appear to be. I don't see any exhaust kits available on the usual websites & the part# shown in the parts manual R029017 isn't showing up on a...
  4. S

    2012 Crusader 602C exhaust configuration

    Thanks. The full model is 22-602C-03. I was sourcing a parts manual from the site listed below but I compared the engine serial #s & I see the manual is for later engines even though it claims to be for 2010-2013. The labels say my engines were actually made in 2011. Do you know somewhere else I...
  5. S

    2012 Crusader 602C exhaust configuration

    Greetings, I have a new to me boat with 2012 Crusader 602C engines. These are the catalyzed exhaust models. I'm in the process of learning the engines & trying the find the maintenance schedules especially for exhaust replacement. I was also looking for the engine anodes & the one in the parts...
  6. S

    Rebuild Sherwood raw water pump

    Follow up 2.5 years later. Rebuilt the pumps successfully, but made the mistake of buying an inexpensive parts kit off of eBay. 1 year after rebuild one of the impellers spun on it's hub. Looked but there was no brand name on the impeller so purchased a real Sherwood replacement. Middle of this...
  7. S

    Rebuild Sherwood raw water pump

    Greetings all, I'm working on rebuilding the Sherwood P-1014 raw water pump from my '97 454XL. I'm following the instructions from Sherwood's catalog. I've got the impeller, cam & wear plate out. I don't see a snap ring that is shown in the diagram to hold on the seal seat or any washer? Has...
  8. S

    1995 Crusader 454 XL TBI engine oil

    That doesn't sound right at all. I have an older model oil change pump like the one at the link with a smaller capacity (~5qt I think). I have to empty it once into my larger storage container before finishing a single engine. It uses a threaded adapter to screw onto the top of the dipstick tube...
  9. S

    Low profile elbow replacement

    Well, as I suspected it was too soon to declare victory. I used my new IR temp gun to record the following temps after getting the engine up to temp. Temps look fine until you get to the HX raw inlet, which I suspect is because the whole HXer was quite warm at that point. I should note that...
  10. S

    Low profile elbow replacement

    Greetings all, Searched thru the forums but didn't find anything specific to my question. I'm considering replacing the elbows on my starboard '97 454XL as its running a little warm & I don't know the age of the elbows having just bought the boat last year.* The Crusader part # for the elbows...
Back
Top