Logo
FULL SITE MENU

Search results

  1. D

    Need help on c30hp lower unit

    Hey all, I have a 1992 Yamaha 30hp (2 cylinder single carb model# c30elrq) outboard that nees new LU seals. The (incorrect) oem manual (c30R) I have for it is accurate except for the lower unit which lists a 4 bolt water pump that is more traditional in design. Unfortunately my motor has a...
  2. D

    1999 Yamaha F50 tilt pin question

    Hey all, Web searched and couldn't find an answer to this anywhere. I recently purchased a new to me 1999 Yamaha f50 tlrx outboard. It has power tilt/trim but the tilt limit pin is missing. Is this needed. Can I damage anything by trimming to far in without it? Thanks
  3. D

    Johnson 175 mystery running problem. (retired omc tech even puzzled)

    A friend of mine purchased a 2000 Johnson 175 60 degree looper (carbed) that we just can't seem to get running. It will run if we force it to by giving quite a bit of throttle, but won't idle. One of the main things to note is that the motor pushes air out of rather than sucking air in the top...
  4. D

    1973 Johnson 20hp conversion to under flywheel coils.

    Hey all, I just picked up a new project, a 1973 johnson 20 with no spark. It is one of the designs Johnson touted as having quicker spark (slow by modern standards) , by using a trigger coil to fire the two ignition coils located closer to the plugs. My other 3, 22ci 18's and 1976 25 use the...
  5. D

    Retrofit time--What is the mFd (uF) on the 398-2203 Condenser?

    Just picked up a 1962 merc 350 (35hp) motor that I am starting to go through. It has a phelon magneto setup. Due to the scarcity (and supposed reliability) of the condensers, I plan to switch them to omc's. It looks like a slightly larger hole drilled into the mag plate and they should...
  6. D

    Fastwin 18hp gearcase needle bearing retrofit.

    Hi all,. The 18s are great motors but noticed that the configuration of the area under the water pump seal went from a bush permanently attached to the case (only available with a new case) to a replaceable needle bearing in 1969 (-72 evinrude). My 1957 has quite a bit of slop in this area and...
  7. D

    115 60 degree looper Tach not working has me stumped!

    Hello everyone this is my first thread here, although past threads have helped me countless times-- Thank you! I have a 96 evinrude 115 and can't get the tachometer to work. Here is what I tried so far. 1. v4 should have the 20 amp charging so checked resist of the stator and was a little...
Back
Top