Fresh water boating where you keep it on a trailer is a whole different story than mooring or slipping a boat in salt water.
Everything will show some corrosion, and it's common to find oxidation on terminals
That said, I haven't had much trouble with the electrical system just a few things, I am going to change the old fuse block under the dashboard that still has glass fuses over the winter.
The OMC Cobra drive/transom assembly looks like any other salt water boat that's moored, it needs to be totally stripped down and repainted, but as far as shifting etc, it works just fine. Basically all I have had to do to it is regular maintenance, pulling it each season, replacing the bellows when needed etc. Only repairs have been rebuilding the trim rams (actually had to replace the ram rods due to corrosion), water pump seal, bellows 2x, that's it, 24 years of use in salt water. I also changed the steering actuator due to leaks, I have a couple of spare ones too lol.
The biggest thing in salt water is exhaust systems, you have to change them eventually, or else you can get leaks into the cyls, I can check these (OMC/Volvo center riser style) by using an endoscope camera via one of plugs on the top of the exhaust elbow. This last set are still good, 7 seasons in salt water so far. I also pull off the rubber hoses and check the condition of the outlets of the elbows, where the corrosion usually starts.
Then there's trailers, here the only things that last are galvanized or aluminum, no painted trailers.
Here's what the inside of the exhaust elbow looks like:
I think my old engine lasted this long (1988 original short block, replaced heads in 2017) because I filled it with antifreeze after draining.
I use Sierra brand PG antifreeze mixed to provide -30*F protection (overkill for here) I like this stuff better than what you typically find because it is good enough to use as engine coolant unlike the storage only type antifreezes....