Here are a bunch of photos... All of the readings are with the key switch off. I don't notice a voltage drop on the battery post of the key switch anymore with the switch on.
This photo shows the beginning voltage at the grey wire that brings the battery positive cable into the motor.
After...
Both of these wires have been.replaced as stated before except for the last few inches and the main battery ground goes into a stud in the control box. The image is very similar to the setup of the motor although i think it is a little misleading in some places....
I have a 1970 johnson 60 hp 3 cylinder 60esl70b and when i hook it up to a new battery i just bought the starter just rapidly spins. Before i thought the jumper just wasnt supplying enough juice and i would hook it directly to the starter and ground on the engine and the starter would engage the...
The engine won't even click when key is turned I measured 12.6 volts at plug. It's a 1970 60 hp. My guess is the fuse. What do talk think? Starter is good I tested it. Measured continuity from battery cables is good to slave solenoid. No voltage at starter however. Thanks again.continuity...