Logo
FULL SITE MENU

Recent content by StevesWhaler

  1. S

    2001 3cyl 90HP Carb Float Setting WME 78 Carburetor

    Answering myself. Apparently WME carbs do have a float height of 9/16. Measure opposite of hinge on float where slope meets front. No gasket, measure from carb body to this point. This means the float does not sit level or parallel to the carb body. Float Tilts up a bit so there will be...
  2. S

    Mercury 90hp 2 stroke flooding

    Make sure the carbs are clear of water... etc See the brass screw on bottom side of the float bowls (hex and flat screwdriver)? Remove each, put a rag under each not to drop it. Then push clear fuel through with the primer bulb. Do this to each of the 3 carbs. If by chance the...
  3. S

    2001 3cyl 90HP Carb Float Setting WME 78 Carburetor

    Hi all, I need some specific help about the float setting specification and how or where to measure. Yes I do have a Seloc Subscription ... the float specification I believe is wrong for WME 78 carburetors. The manual is very generic and I know WME carbs are different. There is an old...
See more
Back
Top