Logo
FULL SITE MENU

Recent content by stanirish

  1. S

    Powerhead and recoil

    The powerhead was taken off I took the powerhead off due to a oil drip I thought was come from the oil pan; turns out when I replaced the fuel pump months earlier I did not install the small rubber gasket for the fuel pump so when the engine was running oil leaked from the fuel pump ( fuel pump...
  2. S

    Powerhead and recoil

    I'm reinstalling the powerhead on a 2015 6hp Tohatsu outboard. I've placed the powerhead on correctly and it sits solidly but when I tighten the bolts securing the powerhead the recoil becomes hard to pull. What am I missing? :unsure:
  3. S

    Tohatsu MFS4CD not starting at all after carb cleaning

    You need to check for spark and maybe remove the ignition coil and inspect, test with a multimeter...
  4. S

    Drive shaft housing gasket

    The pan bolts are tight. Turns out the drive shaft housing gasket isn't the issue. I'm going to replace it with a new one anywat. I discovered that when I replaced the fuel pump last year I carelessly did not put the o-ring back in place. The fuel pump probe (not sure the name) enters the...
  5. S

    Drive shaft housing gasket

    I have 2015 Tohatsu 6hp outboard in good running condition but has a small oil leak when running, the small drip is underneath near the oil drain plug but it's not the oil drain plug or oil temp probe. I removed the powerhead and the only noticeable issue may be the drive shaft housing gasket...
See more
Back
Top