Logo
FULL SITE MENU

Recent content by sqrlnut

  1. S

    A/C operation on 1009 Luhrs

    Good point.... i am getting power to the unit from the breakers. the control panel not so much. i will try to access and track down the line tomorrow and will need to figure out the wiring diagram. im hoping that just the control panels are shot. i didnt notice any fuses blown or wires...
  2. S

    A/C operation on 1009 Luhrs

    the A/C (and heat) units on our1990 Luhrs 3400 MY does not have instructions. I turned on the breakers to both units and neither of the T-stat;/ control panel show power. Can anyone explain how the system works, the process to turning it on and if the T-stat panel needs replaced what ones will...
  3. S

    A/C not running

    the A/C units on our1990 Luhrs 3400 MY does not have instructions. I turned on the breakers to both units and neither of the T-stat;/ control panel show power. can anyone explain how the system works..
  4. S

    I 1990 luhrs 3400 electrical issue

    Sobi had shore power, and when I turned the selector switch from shore 1/2 to shoer 1 and back, I over shot it and hit the gen. Then when I switched back to 1/2, I had no power.is there a fuse or something I'm missing? The switch is original and the boat sat for 7 years so it could be shot... Thanks
  5. S

    1986 Crusader 454 electronic ignition conversion problem

    is there a preference on brands or kits that are recommended. i was looking at the A-Team Performance Marine HEI Electronic Distributor 65K Coil Compatible with 350 454 V8 Mercruiser OMC 5.0 5.7 7.4, since its only 200. bucks just confusing when one is 200 and another is 600. and the...
  6. S

    1986 Crusader 454 electronic ignition conversion problem

    sorry, i planned on swapping the whole distributor since i believe it is still the original with original wires as well
  7. S

    1986 Crusader 454 electronic ignition conversion problem

    Guys, i'm new here and would like to swap out my old distributors on my 1990 crusader 454s. i saw a few EIs around 200.00. what all would be involved with a swap out. thanks
  8. S

    1991 Luhrs 3400 Crusader 454

    i did/do test the systems before replacing. the bilge switch was bad (on 2 bilges of the 3) and 1 bilge i replaced bc the pump cover was so broke from sucking up stuff through the strainer and Rule dont sell the pump cover. i relaced that one with an auto flat 1500.
  9. S

    1991 Luhrs 3400 Crusader 454

    so i got the boat from Oceanport to Long beach the other day on its first trip in 7 years. motors were steaming a little but maintained temp fine, UNTIL,,,, one stopped running due to overheating, (the alarm didnt sound) thing with all the swells we had one of the corroded connectors dislodged...
  10. S

    Gauge HELP

    there is power to the switch (they are on the same one) im thinking if there in series it could be the wire to the 1 anchor bulb not getting power. not sure they would wire it that way though
  11. S

    Gauge HELP

    on the nav lights, its not the switch, the anchor light comes on (but only one of them do) and its no not getting power to the others not that i learned what an optical tac is LOL, i might just have to get one, would a cheap one suffice for how much i would use it?
  12. S

    Gauge HELP

    so i installed all the gauges: the P side Tac and water move slightly when turned on but will not produce a reading. the S side all work but the Tac bounces a 200-300 rpm i just found out my nav lights aren't getting power as well. does anyone have a Luhrs wiring diagram that will work for my...
  13. S

    Gauge HELP

    so i got all the gauges installed, the P side water temp and tac moves when i turn on power but neither one read. the S side tac bounces when the baot is running. I assume its a ground issue... i also have an issue with my nav lights not working. does anyone have a Luhrs wiring diagram that...
  14. S

    Gauge HELP

    So the Tac sais to hook on of the wires to the negative of the coil? What wire would that be?
  15. S

    Crusader 454 tune up

    got the fuel lines and carb done, started doing the gauges, the next issue is the boat needs to be out of the marina by the 29th so i'm kinda rushing its sea worthiness LOL. I'm looking for someone to bring it from Oceanport to LBI the Captain i had cant do it now. i digressed,,,, so i want to...
See more
Back
Top