Logo
FULL SITE MENU

Recent content by Sleepwalker

  1. S

    Prop Issue

    Thanks, I was able to fashion a wheel puller using ratchet strap material looped around each blade. Came off pretty easy. All dried grease inside. Will now do yearly.
  2. S

    Prop Issue

    Thanks! I did some googling and understand it's not uncommon. At least I know there's nothing left to unscrew.
  3. S

    Prop Issue

    Thanks. That's what I thought. I doubt it's ever been off. Been used in salt but don't believe it sat.
  4. S

    Prop Issue

    Hi- feeling stupid. I have a '95 90 hp ELPTO that I am trying to remove the prop on. I have removed the nut and the retaining washer with the tabs. According to everything I've seen, the prop should slide right off but it won't budge. Am I missing something? ---Thanks, Rich (the liquid you...
  5. S

    '95 90 hp Merc Shift Question

    Thanks!
  6. S

    '95 90 hp Merc Shift Question

    Thanks! Agree cable replacement makes sense for the first step. Will look into SEI, too.
  7. S

    '95 90 hp Merc Shift Question

    I just picked up a '95 90 hp Merc ELPTO. In the most recent repair work the previous owner indicated a clicking noise in neutral. The work order states that there is no more adjustment left on the shift cable. I know cables are not supposed to stretch so does it mean something else is worn or...
  8. S

    Sparkplug Gap

    A general question here. My owners manual says to gap the NGK plug at .035". NGK (per this site) says to gap the same plug at .028". So I'm confused which I should do? Thanks, Rich
  9. S

    Thermostat Gasket

    Just received these gaskets that have the 3'd hole in them with the brass grommet for grounding I guess. Both the thermostat housing and the cover surfaces are flat. Can I still use these? Worried about the the brass not making a tight seal. Or does it crush right down? Thanks, Rich
  10. S

    Cooling Question

    I have a closed system cooling on my V-6. Running on the trailer I have the sea water intake closed and run the freshwater hose into the strainer. I run it at the recommended up to 1200 rpm. When warming up I can see the temp gauge go up and then see the thermostat kick in. Using the gun...
  11. S

    Rochester Inlet Leak Quad

    Hi- At least I think it's the inlet. Trying to work thru using new washers etc and having no luck. Right below the inlet nut is a piece that protrudes out about and inch or so, maybe finger size diameter, appears to be some kind of plastic. Does anyone know what it is? It doesn't show...
  12. S

    Dexron Question

    Is there a general rule of thumb on when to change your transmission fluid? By number of engine hours or age? I couldn't find anything in my old operation manual, only the spec for the fluid. Thanks, Rich
  13. S

    Oil Pressure

    Another gauge question. What would cause the oil pressure gauge to be pegged all the way to the right when the engine is running? Thanks, Rich
  14. S

    Hour Meters

    Hi- Do they go bad? Mine (not digital) just quit and was working. I verified 12v to it when it was running. Anything else I should check? Thanks, Rich
  15. S

    Shout Out

    Hi All. I want to give MakoMark a special shout out for hanging in there with my recent non starting problem. I know he's been on this forum for a long time and we all appreciate his effort and all the other veterans who don't mind helping us do it yourselfers to get thru things. Great...
See more
Back
Top