Logo
FULL SITE MENU

Recent content by sledman1

  1. S

    2007, 115 HP 4 stroke stalling when going back to idle

    I have a problem with my outboard stalling when you go from throttle back to idle. It will stall when you do this unless you go very slowly from throttle back to neutral. It seems to idle fine but does not like coming of the throttle. Any suggestions as to what might cause this would be...
  2. S

    Evinrude E90TLCCA, 90 HP V4. How do you disconnect shift shaft??

    Trying to replace the impeller on an Evinrude 90HP V4 (E90TLCCA) outboard. I can't figure out where/how to disconnect the shift shaft so I can drop the lower unit. I can see where the shift cable comes up thru the cowl under the lower carb but just don't see how it is disconnected...
  3. S

    Gen 2 remote lower unit oil reservoir hose replacement between bell housing and thru bulkhead. HELP!

    Got a hole in the hose that goes between the thru bulkhead and the bell housing that carries the lower unit oil from the remote reservoir. It is a 10 inch long hose. Looking for some help with replacing the hose. I have the outdrive off and managed to disconnect the hose from the bulkhead side...
  4. S

    Gen 2 remote lower unit oil reservoir hose replacement between bell housing and thru bulkhead. HELP!

    Got a hole in the hose that goes between the thru bulkhead and the bell housing that carries the lower unit oil from the remote reservoir. It is a 10 inch long hose. Looking for some help with replacing the hose. I have the outdrive off and managed to disconnect the hose from the bulkhead...
  5. S

    What is it worth? 50 HP 4 stroke EFI Evinrude

    I am looking at a 2000 Evinrude 4 stroke EFI motor. no history on the engine is available. Going to do a compression test on it to try and get a sense of how many hours are on it. Just wondering what everyone thinks it is worth in good running condition?
  6. S

    2000 Evinrude (Suzuki) 50 HP 4 stroke engine compression range

    Looking at a 2000 50 HP Evinrude 4 stroke, fuel injected engine. Does anyone know what the compression should be for this motor? No history on this engine so I am trying to determine hours on this engine from the compression readings. All cylinders are reading within 2 PSI. I need to verify my...
  7. S

    2000 Evinrude (Suzuki) 50 HP 4 stroke engine compression range

    Looking at a 2000 50 HP Evinrude 4 stroke, fuel injected engine. Does anyone know what the compression should be for this motor? No history on this engine so I am trying to determine hours on this engine from the compression readings. All cylinders are reading within 2 PSI. I need to verify my...
  8. S

    2000 Evinrude 50 HP 4 stroke engine compression range

    Looking at a 2000 50 HP Evinrude 4 stroke, fuel injected engine. Does anyone know what the compression should be for this motor? No history on this engine so I am trying to determine hours on this engine from the compression readings. All cylinders are reading within 2 PSI. I need to verify...
See more
Back
Top