Logo
FULL SITE MENU

Recent content by Shearpin2

  1. S

    Bleed hose diagram 225hp

    I'm working on a 1980-81 mercury 225hp ser# 5929403. Placing her back into service. I have a hiccup. As the title reads. Need info on the correct info for the bleed hose routing. And I can't find it anywhere, how the top bearing and bottom bearing gets the lub? I see no hose ports for hose...
  2. S

    Cdi voltage out put

    Interesting, your thought reinforce's my thoughts on this system but not completely. Your see inside the the ecu , whether in one section, of the ecu or spread out the containment is a functioning " box" is the operation of a cdi, that is controlled, by the ecu. It sends out a controlled...
  3. S

    Cdi voltage out put

    2011 yamaha T50TLR EFI Can someone tell me the voltage output to coil from to cdi to supply the coils ( wast spark) system. Also what voltage , at cranking , for the stator y1,y2 and y3 . Tasted at the voltage reg. Connection. I have already installed new coils have same problem. One plug per...
  4. S

    Fuel over flow.

    Mercury 75hp OD136078 The problem: Pump the fuel bulb to fill carbs b4 cold start. #1 carb over fill tube in throttle bore spits/spills fuel as i pump bulb. #2 carb over flow spit/spills fuel after thrid-forth primer bulb pump. #3 carb spits/spills fuel after forth/fifth pump the bulb...
  5. S

    Spark plug socket size.

    Evinrude 50 hp socket plug wrench size . Model number E50pl4Ss. Does this stubborn engine take a special socket? Thin wall.? 18mm? 5/8? 9/16? Never in 35+ years have I had a plug so difficult to remove. This seem to be the item that gets you to bring it back to dealership, but I'm not...
See more
Back
Top