Logo
FULL SITE MENU

Recent content by Sfox

  1. S

    Johnson Evinrude 115 hp model J115PXSOR

    Hi y’all my engine dies out at low idle..a lot if I control it from under the hood it is fine. I would just like to set the idle up a little about the thickness of a razor blade it isnt much but I don’t need a whole lot going to try to add a photo wondering if this is where I can set idle up a...
  2. S

    2005 Johnson 115 hp 2 stroke dies easily at low idle

    Thanks for the reply, good stuff. I can use these ideas
  3. S

    Fuel type 2005 Johnson 115 hp 2cycle

    Thanks yeah don’t have an owners manual. I guess I was just curious if everyone uses a mid grade or higher fuel type and I meant 85 octane not ethanol just to be clear.
  4. S

    2005 Johnson 115 hp 2 stroke dies easily at low idle

    I am not sure how to advance the idle and don’t have a timing light. But I think if I raised the idle just a tad it wouldnt always be dying while trying to maneuver slowly like when trying to to load onto trailer or floating slowly in toward a dock. Having to restart several times during slow...
  5. S

    Fuel type 2005 Johnson 115 hp 2cycle

    Got it thanks.
  6. S

    Fuel type 2005 Johnson 115 hp 2cycle

    Could you expand on that ? Why?, and or what should be used instead ? This is the fuel offered everywhere.
  7. S

    Fuel type 2005 Johnson 115 hp 2cycle

    How many use the e85 fuel in this motor
  8. S

    Scuppers

    Yeah those scuppers are factory height and yes I am changing the hatch so it has a better seal That hatch, to me, appears to have been added post factory. Somebody wanted an easier access to the bilge maybe. I was just hoping scuppers that everyone has on their boat were of different degrees of...
  9. S

    Scuppers

  10. S

    Scuppers

    Yes they let water out of the well while underway and then supposed to stop water while sitting still.
  11. S

    Scuppers

    These allow a lot of water into the well
  12. S

    Scuppers

    I always have trouble with loading photos here I don’t think it works well
  13. S

    At My Wits End: Lower Unit Seals (Shiftshaft/Driveshaft) Replaced, But Still Seeing Leaking Fluid!

    You also could get seepage if the seal shaft had been nicked while getting the seals installed.
  14. S

    Scuppers

    I have the type with the little ping pong ball in them they don’t seal off water worth a darn and allows the well to take water which in turn goes under a hatch to the bilge pump. Constant cycling water. I think it cannot be stock to have a hatch in a water well anyway but there it is bad seal...
  15. S

    Motor tilt intermittent

    weird won’t always work and if it starts to act like it won’t lift hittin up/down lever quickly seems to make a difference. Will low Hydralic fluid in the pump cause that? Sometimes it will groan while lifting. Seems like it works 90% of the time. The ten percent is at the ramp or in low water...
See more
Back
Top