Logo
FULL SITE MENU

Recent content by roscopico

  1. R

    Yamaha hard to start F40TLRA

    "Clean carbs back in april, st "Clean carbs back in april, start-up runs ok. Did not drain gas out of all the carbs I think only # 3 I did. Anyway getting the same hard to start issue. So after three month I try to start up, same issue prior to cleaning the carbs in april. When I...
  2. R

    Connect a secondary engine that has remote

    "HI I would like to connec "HI I would like to connect a second engine 9.9 that will share the steering with my F40tlra 40 hp outbroad. I think this is possible, however the steering connects to the yamaha right now, how should I connect the 9.9 which also have the remote. to use...
  3. R

    Yamaha Kit to change the whole or partial

    "Why do I have to buy the whol "Why do I have to buy the whole kit, all I need to is to check and clean for contamination in the carbs. Can't I just getaway with changing the required gasket based upon the service manual. Do I really nead to change the float? Is there a service log I could...
  4. R

    YOU GUYS SHOULD READ THIS

    "i hae seen the red stabil gel "i hae seen the red stabil gell with e-10! hence the reason the new marine stabil!!!! ARE YOU READING THE FINE LINES HERE, I EXTRACTED THIS FROM A SUPER MASTER MARINE TECH."
  5. R

    What the price for a DT60 8284

    "Broken, not working thanks "Broken, not working thanks"
  6. R

    IS GURU G JUSTINTIME on RampR

    "Just to let you know, some of "Just to let you know, some of us are dying to hear from you. Anyway thank you so much for all the help you provide and all the other guys that do also. I tell ya; my tab in heaven will be big. Cause I buying the mojito's big time"
  7. R

    Evinrude 95 1968 model 98 Sportwin

    "Just got myself one of these "Just got myself one of these baby. I know I am in the yamaha chat, but does any one of you have a service manual for this model. I am not sure of the gas mixture 25:1 or 50:1 also the lady I purchased it from, said it was sitting for 5 years. Is there a...
  8. R

    Evinrude 95 1968 model 98 Sportwin

    "Just got myself one of these "Just got myself one of these baby. I know I am in the yamaha chat, but does any one of you have a service manual for this model. I am not sure of the gas mixture 25:1 or 50:1 also the lady I purchased it from, said it was sitting for 5 years. Is there a...
  9. R

    95 model 98 year 1968 sportswin

    "Gentlemen, I purchase a 9. "Gentlemen, I purchase a 9.5 model 9822 year 1968. lady told me it was sitting 5 year now. how should I approach starting up this baby. Look at the engine setup, looks real simple. anyone have a pre-check list, or a service manual they could share. I have...
  10. R

    2002 F40tlra 40 HP 4 stroke 3 cylinder

    "Engine will start and rev at "Engine will start and rev at high RPM and hold, as soon as I release choke to default engine idling. Engine shuts down. Question: should I change engine idle? Could it be I have a restriction in the carb. Do I need to rebuld the carbs. Using aux tank to...
  11. R

    JUSTINTIME CAN YOU PLEASE ANSWER THIS

    "2002 40 HP F40tlra, need to k "2002 40 HP F40tlra, need to know the size of the adapter for the vacuum hole to sync carburator. Also need to know whats the cheapest sync tool to use to sync the 3-carbs. Can I use this one below...
  12. R

    TACHOMETER amp FUEL AND VACUUM GUAGE SET

    "I need to purchase tacometer "I need to purchase tacometer fuel and vacuum guage set to work on my 2002 4 stroke 40 HP engine. Anyboy knows of an equivalent set to yamaha, that could do the the job. thanks"
  13. R

    Question for just in time

    "I am pulling my hairs on this "I am pulling my hairs on this one. Ok, I get the the Yammy 40 HP 4 stroke out in the water, idle is rough, however I throw quick into drive to gain aceleration. Problem is that it could idle high on with no shutdown. I could put it in drive and it runs no...
  14. R

    More Speed on my yamaha 2002 40HP 4 cycle

    "After playing around with the "After playing around with the trottle cable. I see the possiblity of opening the carbs for more rev's/Speed. However the existing remote trottle, will not give you that option of more speed(OEM Version) Is there a remote I could purchase to get more push down...
  15. R

    Tools required to rebuilding carbs

    "Yamaha 40 HP 4 stroke, 3 barr "Yamaha 40 HP 4 stroke, 3 barrel carbs. What tools are required to rebuilt and test, example synconization of the 3 carbs. And how do remove the 3 screws from the breather manifold that connects to the carb. Is there a special tool for this."
See more
Back
Top