Logo
FULL SITE MENU

Recent content by Rhigley

  1. R

    trim gauge on Evinrude 100 XP

    I bought a cheep trim gauge for my boat. I am trying to wire it up before I drill the hole in the dash. I hooked up the white with light brown strip to the signal post. Ground (black) to ground and purple to ignition. I turn on the power and the ignition switch and move the motor and the gauge...
  2. R

    How to set WOT on 1990 evinrude 100

    I'm looking into checking the WOT setting on my motor. I changed out the prop but they look to be about the same but I get a reading of over 6000 rpm when WOT is set. Other than prop and throttle is their another way to keep the motor from over reving?
  3. R

    Fuel Pump for XP 100

    I know I need a fuel pump repair. My question is what is the best way for me to go. Rebuild fuel pump on the already bypassed VRO unit or go with the 0438556 - Fuel Pump (for 88) ?
  4. R

    Tach. Pulse setting for VE 100 SLESB

    what should my Tach. Pulse setting be for this evinrude outboard?
  5. R

    1990 xp 100 Evinrude

    I changed out both filters{water separator and inline) fresh gas and it still starves at WOT after a few seconds. On e more note is that at idle my tac says 1000 rpms and in gear it drops to 700 rpm but wide open goes to over 6000. I pulled the throttle back to 5000rpm and it ran longer but...
  6. R

    Spark plugs

    What is the difference between marine spark plug and a auto spark plug?
  7. R

    1990 xp 100 Evinrude

    I ran my boat today and it ran great until I went to full throttle. After about 30 seconds it would fall on its face like it was starving. I'm thinking change out the fuel filter and get some fresh gas. Am I on the right track? Also after running for an hour or so the idle is a bit low. Could...
See more
Back
Top