Logo

Recent content by Pells

  1. P

    Honda BF8D overheating (maybe?)

    I found a blockage at the bottom of the water jacket where the anode should be. It appears that one or two passages to the bottom cylinder were blocked. It cleaned up easily, and the ports seem to be clear. Broke the head off one bolt:). Ordered anode, bolts, & gasket. I'll put it together...
  2. P

    Honda BF8D overheating (maybe?)

    I installed a water pump kit. The old impeller looks OK; it has all the arms and is flexible. Replaced the impeller anyway. Same problem, the engine runs smoothly from cold start until the block measures 180°F (next to the temperature sensor). Then it shuts down, like it is running on one...
  3. P

    Honda BF8D overheating (maybe?)

    Can you recommend a water vinegar ratio? Perhaps 10:1 or 20:1? I assume this will help dissolve some deposits/ buildup? Thanks, -Ken
  4. P

    Honda BF8D overheating (maybe?)

    Thanks for your recommendation. I'll inspect & replace the water pump and report back. -Ken
  5. P

    Honda BF8D overheating (maybe?)

    Hi, I'm new to marineengine, hope someone can help me out. I have seen this problem described in several other forums; however, no one has reported a fix. I have a Honda outboard model # BF8D-BAAJ-1802157. I am the original owner, purchased about 10 years ago. It is used infrequently to move...
Back
Top