So, I’m back to the original E70ELCD I posted about. Got the power head off and pistons out. Below are a few pics. Looking for opinions on what may have caused the #2 piston to have burst (see the hole). It doesn’t appears that it damaged anything on the camshaft. Other than the piston...
After a lot of patience, but got the prop off this beast, but need to ask how to remove washer/thrust washer (not sure if that’s what it really is). Looks like it’s part of the shaft, but I’m thinking it’s just rusted on there. Should I just hit the **** out of it? Suggestions on how to...
On a more positive note, I picked up the below shown motor from a guys backyard for $100 bucks. Compression was 140 on all 4 cylinders and it does run, so got work to do but hoping I get replace the 70 hp with this 85 hp with your help here. I’ll post questions as I begin to check out the...
Just following up on this to close the loop. Photo’s below show the brick building on their website and the other photo was taken by a friend who visited the address on their website. Place your order today !!!
Any ideas on removing a stuck flywheel??
This was an interesting post ...
http://www.marineengine.com/boat-forum/showthread.php?401157-Pulling-a-stuck-flywheel
Hello everyone,
As my User Name suggests, I’m old (60+) yet a newbie (1-) to boating. Loving it so far. If someone can provide me with a bit of guidance given the below synopsis, I’d greatly appreciate it.
Thinking I’d start small, last year I bought an old Cimarron boat with a ‘86 Evinrude...