Logo
FULL SITE MENU

Recent content by Mujibar

  1. Mujibar

    Thank you Ricardo and El- Pescador

    OKAY!!!! After 2 years after buying it, my boat is scheduled for the water tomorrow! Just in time for my birthday. It has been a learning experience. Made easier by the EXPERT help and knowledge of RICARDO and El-Pescador. Thank you both. Very Much! I also wish to thank all the others who...
  2. Mujibar

    Aq 270t hydraulic tilt

    I have been searching for a schematic of a 1970's aq270t tilt system. None of the manuals I have, seem to have a schematic or the repair instructions for the old style pump. I have not yet removed the pump system so I have no markings to give you. It is the rectangular box seen in the...
  3. Mujibar

    Trim tab installation

    I have acquired a set of Bennett trim tabs that i am installing on my 22 cuddy. The boat is rack stored and does not have, nor will it have anti-fouling paint. The question I have is, do I only use sealer in the screw holes? What would be the result of using sealer on the entire surface...
  4. Mujibar

    Props for pre 1994 270aqT outdrive

    Not sure if this is a return to the tree of knowledge, or the fount of information. LOL The "restoration" of the drive system is coming along, if slowly. The engine is ready. the stern drive after extensive repairs to the lower 289 unit I purchased is almost ready. The repaired PDS and...
  5. Mujibar

    Props for pre 1994 270aqT outdrive

    photos of the "270" ford 351W bell housing are now available. one of the bearings was a sealed bearing
  6. Mujibar

    Props for pre 1994 270aqT outdrive

  7. Mujibar

    Props for pre 1994 270aqT outdrive

    I went out, found and obtained, probably the worst example of a 280 drive with 1.61:1 gear ratio available. (pictures attached) I have spent a week getting it apart. Liquid wrench, heat and impact allen wrenches can be your friends! Smells like a oil polluted bay bottom at low tide. Thank...
  8. Mujibar

    Props for pre 1994 270aqT outdrive

    These are the photos that did not show up in the previous post. Thank you Jerry
  9. Mujibar

    Props for pre 1994 270aqT outdrive

    Below are some pictures of the drive. hopefully they are adequate. The new prop seems to fit well using only the prop, locking ring and cone. The small hole in the back center of the shaft is unthreaded. Rain showers today cut my time short and tomorrow I will do more extensive measuring...
  10. Mujibar

    Props for pre 1994 270aqT outdrive

    I have acquired a 22.5' custom built 1975 cuddy "cruiser"?. It has not been in the water for at least 12 years. It is powered by a 351w engine. It has a 270aqT, (I think, plate says 270T) outdrive. I just spent the day turning a prop and its hub into aluminum paperweights. The years of...
See more
Back
Top