Logo

Recent content by mecano69

  1. M

    would like the wiring diagrame for a minn kota power up

    i bought a minn kota (power trim )an i would like to know the wiring diagrame to make work thx
  2. M

    lower unit is comming down slowly

    i have a 1983 glastron whit a 4 cylinder an i always have to upper the foot cause is always comming down ,what should i do .
  3. M

    can i change the prop shaft on my mercury motor

    i there i have a 1960 40hp mercury serie 400e an im having problem to find a prop for it .so im wondering of there is a shaft that i can put in but whit a 12-14 spline .
  4. M

    rpm

    ok thanks
  5. M

    rpm

    where do you connect the wire from the rpm to a 1960 mercury serie 400e 40hp 4 cylinder .
  6. M

    JONHSON 25HP 3 CYL 1995

    good news i put the boat on the lac an didnt stall .dont no what happen
  7. M

    JONHSON 25HP 3 CYL 1995

    MY 25HP START RELL GOOD BUT STOP AFTER 3 -5 MIN AFTER .SEEM LIKE THE FIRE IS CUTTING .DONT KNOW WHAT TO DO ,
  8. M

    1995 jonhson 3 cylinder back firring

    i m gone a clean the 3 carb an check if its better
  9. M

    1995 jonhson 3 cylinder back firring

    change the cdibox an waterpump .did not do anything else.motor start but after a few minute it start to back fire an i have to put the chock on the motor to make it work Welcome, I will be happy to assist you. If you have a question or need clarification please post back at any...
  10. M

    the firer cut on my 25 hp jonhson 1996

    its a 3 cylinder 25hp jonhson
  11. M

    the firer cut on my 25 hp jonhson 1996

    i can start it when its cold but when it ran for 2-3 min it stop an thees not fire
  12. M

    how to know if your is a 7.5hp or a 9.8hp mercury

    whith out the serial an model num ????
Back
Top