Logo
FULL SITE MENU

Recent content by mad dog

  1. M

    mad dog

    Ref. recent post ( problem removing leg) leg came of a treat due to advice from forum but found no gimble bearing only rear end of velvet drive trans. having removed tail housing the shaft has internal spline and is badly pitted where the very rusty needle roller runs ,suspect this is cause of...
  2. M

    mad dog

    hoping some one may be able to help mercruiser with v8 has not been run for 18 years left in garage run engine up drive noisy near top , oil level ok tried splitting leg from stern undid 6 nuts leg moved 20mm but even after spraying inside with release oil and trying levers unable to remove leg...
  3. M

    mad dog

    old yanmar yse8 problem starting cold or hot cranks over fast with de-compressor down,but will not turn a complete revolution when de-compressor off seems to go solid, changed batteryfuel ok when after many tries it does start it runs well with no strange noises or smoking seems to be getting worse
See more
Back
Top