Logo
FULL SITE MENU

Recent content by ma_ko

  1. M

    Help identyfying boat

    My dad just bought a boat, a Glastron but does anyone know what model and maybe year it is? Here are the photos: Thanks in advance
  2. M

    What is this element + question about carbs screws

    by the way this is the boat it came with and also one more question about the screw in the very center of the photo: is this for adjusting rpm? do you know where can i find any info about how should it be set. In a service manual i found there's nothing about this. sorry for many...
  3. M

    What is this element + question about carbs screws

    Sorry i'm just starting with the outboards. Manual says 1:80? Oil tank was removed by previous owner. I'm using mix of oil and gasoline. And about the screws i meant the ones above them (i'm writing this post on behalf of my dad which is not well versed in the internet), the ones with red...
  4. M

    What is this element + question about carbs screws

    I've bough a boat with 90hp 2 stroke mercury engine from 1991 or 1992. The engine runs okay but i was wondering what was this element: it's not present on the schematic in service manual. It has 4 wires. Black goes to ground, blue goes to the ignition module, and two top ones go to the coil...
  5. M

    Help identyfying Mercury engine

    Yeah I'm in Europe and it's probably a belgium made one
  6. M

    Help identyfying Mercury engine

    It's a 90hp 2T engine with model number 9614390. Unfotunately it does not have any model name plate and looks like that (photo from the internet, but it's the exact same) i'm looking for maybe name of the exact model, so I can look for some parts for it Thanks in advance
  7. M

    Help with 1986 Evinrude BE40ELCDE engine - rough idle

    First of all sorry for my english, I'm from Poland & still learning. I have cleaned carburetors, installed new plugs, checked pressure: 10.5 bar on each cylinder - looks like the ignition is getting disrupted(?). I hooked up a strobe light timing at idle (~800RPM) is 4 degrees, anyone know how...
See more
Back
Top