Logo
FULL SITE MENU

Recent content by larry29936

  1. L

    Placement of primer bulb on 2 tank setup

    I'm installing a second 6 gallon gas tank on my 16' McKee with a 70 HP Johnson so I'll have one tank on each side of the splash well. The tank selector valve is ahead of the fuel/water separator. Should I use a single primer bulb between the fuel/water separator and engine or primer bulbs...
  2. L

    Easiest way to remove trim/tilt unit - 1987 50HP Johnson J50TLCUD

    Here you go Boobie: This picture shows the pump and tilt cylinder. The trim cylinder is on the opposite side of the engine. This is a picture of the top of the trim cylinder with neoprene showing around shaft
  3. L

    Easiest way to remove trim/tilt unit - 1987 50HP Johnson J50TLCUD

    I'd really like to overhaul the trim/tilt system because the trim cylinder has a piece of black neoprene (part of a seal?) showing around the shaft at the top of the cylinder and the tilt isn't coming all the way up. I'd like to rebuild both cylinders but the bolt thru the top of the trim...
See more
Back
Top