Logo
FULL SITE MENU

Recent content by lakewind

  1. L

    ARCO Marine starters

    Has anyone had any negative or positive experiences on Yamaha outboards with Arco marine products in particular starter motors? They say they are manufactured in Pensacola FL and are a little pricey for aftermarket starters but only about 60% of the cost of stock. Their one year warranty covers...
  2. L

    Yamaha service manual

    I recently bought a 2005 Yamaha F25 ELHD.I am trying to locate a service manual for this motor.Yamaha has a website that offers original service manuals but they don't go back to 2005.I have heard some negativity about SELOC service manuals and after glancing over their service manual for Yamaha...
  3. L

    Yamaha service manual

    I recently bought a 2005 Yamaha F25 ELHD.I am trying to locate a service manual for this motor.Yamaha has a website that offers original service manuals but they don't go back to 2005.I have heard some negativity about SELOC service manuals and after glancing over their service manual for Yamaha...
  4. L

    Merc 350 Mag MPI no spark

    I have recently purchased a 1996 Searay sundancer 240 with a Mercury 350 Mag MPI that's not getting spark at the plugs.Does anyone know of any issues with the electronic ignition on this engine? I've installed a new battery and the engine turns over freely.I've worked on outboards in the past...
  5. L

    How hot should evinrude 4hp run?

    I was running my 1978 evinrude 4 hp model 4806e in a 55 gal. barrel today for about 15 minutes.Seemed to be running a little hot after about 15 minutes.I was dripping water on cylinder head and it would boil off.I have replaced the water pump impeller,cleaned water passages.Actually pulled the...
  6. L

    Evinrude ignition coil

    My Evinrude 1978 4 hp model 4806e is producing a weak and intermittent spark on the #1 cylinder.It has electronic ignition.The power pack has been replaced after a mechanic told me it was bad but still no spark.Does anyone know the procedure for testing the ignition coil on this engine? Any help...
  7. L

    Envinrude 4HP only runs fully choked

    My 1978 Evinrude 4 HP model 4806e out board only wants to run with choke.It will idle roughly with choke in but wont reach RPM.Carb has been thoroughly cleaned.Inspected reeds good.Fresh fuel and oil.Primer bulb pumps up hard.New plugs.One thing I noticed the top plug was kind of black and oily...
See more
Back
Top