Logo
FULL SITE MENU

Recent content by Jaycar85

  1. J

    Yamaha 25 head gasket issue

    Upon assembly of the head power head the manual says lightly oil the head bolts (which I did) but here lies the issue apparently my light is not the same as theirs. After torquing to spec. I see oil around head. Will this effect the seal? And if so should I take it off and clean it or...
  2. J

    Yamaha 25 crank seal question

    I'm rebuilding a 2005 Yamaha 25 horsepower 2-stroke outboard I have it tore all the way down to the crank. My question is on the lower seal housing inside there are two seals that fit over crank shaft. The seal on the upper bearing said use locktite 271 which I used. The repair Manuel says...
  3. J

    Yamaha 25 crank rebuild

    I'm doing a rebuild of a 2005 Yamaha 25 and I'm down to the crank it is a one piece I am unable to remove the rods or bearings but there is one bearing at the end. The parts diagram shows they sell the bearings by them selves. I guess my question is can I replace it and if so how? Is it...
See more
Back
Top