Logo
FULL SITE MENU

Recent content by Intermediate Mariner

  1. I

    ?!?! Can I use '68 pistons for a '62 rebore?

    Morning Gents, Working on a 1962 Evinrude M#35530 Lark 40hp. Have a bad cylinder and need to rebore it. The original oversize cylinder for that motor (#378697) is NOT AVAILABLE ANYWHERE IN THE WORLD that I have found, not on ebay, not anywhere. The '68 piston is a little bit more available...
  2. I

    Is 35hp sea king the same block as 40hp 'rude

    Hi, Have 2 bad 1961&1962 evinrude 40hp blocks with scored cyl on both go figure. I also have a 1960 Sea King 35 hp laying around and the blocks appear the same. Does anyone know if the bare cyl/crankcase from the '60 SK will fit the 62 40hp evinrude (head, lower leg, intake, etc)?? Thanks...
  3. I

    No one at iboats could help.. which rings for '1968 40 hp

    I ran this buy the guys at iboats and figured I would give this board a try. This would be a technical one for the omc guys!! I am working on a '62 40hp evinrude. I finally got compression up to a strong 90 on the top and a weak 30 on the bottom... bottom cylinder wall is gouged almost all the...
  4. I

    1962 40 hp Powerhead: Pistons Loose?

    :eek:Hello Everyone. Hopefully some of you have probably seen this before or know about it. In performing a variety of repairs I have removed powerhead and cylinder head. I had the PH on the bench with the top of the pistons exposed and noticed that the pistons are pretty darn loose! I mean I...
See more
Back
Top