Logo
FULL SITE MENU

Recent content by ifisherman

  1. I

    Some help for a newbie.

    Howdy all. I picked up a 2018 20hp four stroke tiller. It is on a small Carolina Skiff J14. I have had it out on the water a few times and it is a blast. I have a couple questions some more experienced boaters might be able to help with. First off is the prop. So far the performance is solid...
  2. I

    Outboard height importance.

    Howdy everyone. I purchased a new 20hp Merc motor to replace an old Honda. Of course the new motor does not line up with the holes of the old motor in the transom. The new holes would be placed right above the old, close enough that there would be a tiny amount of material between the two...
  3. I

    New Mercury question.

    Howdy everyone. I recently picked up a new 2018 20hp 4stroke to replace an old Honda 4stroke. Question I have is on the old Motor I use to pop off the fuel line and let the motor run till it stalls when I knew I was not going to use the motor again for a month or so. Should I do that with the...
  4. I

    Shaft length question.

    Howdy all. I have a 2005 Carolina Skiff J14. The transom measured 16". It currently has a 15hp Honda and the shaft measures 17 inches. I might upgrade the motor to a new one and use the old 15 on a friends boat. Question is I see only 15" or 20" shaft options. Am I measuring my outboard...
  5. I

    Honda BF15A problem.

    Hello everyone. This is my first post. Been surfing the site for a few months and it is a great help. I have a new to me Honda BF15A 4stroke. 2006 I believe. I picked it up a few months ago, it had been sitting for a couple years. It started up and I replaced the impeller prop to get the water...
See more
Back
Top