Logo
FULL SITE MENU

Recent content by Gthompson125

  1. G

    Crusader 350

    Thank you, going to try it first thing tomorrow morning since I have the day off to really get into it since the weather supposed to be bearable and not a ton of humidity. I’ll keep you posted on how I make out.
  2. G

    Crusader 350

    OK, I believe that makes sense to me if I put a voltmeter to + side of the coil and ground to the block should I get 12 V or somewhere around nine from what I’ve read with the Mallory ignition Of course I’m trying to do this in 101° weather with 95% humidity😂 Somebody told me a long time ago...
  3. G

    Crusader 350

  4. G

    Crusader 350

    OK, I believe that makes sense to me if I put a voltmeter to + side of the coil and ground to the block should I get 12 V or somewhere around nine from what I’ve read with the Mallory ignition
  5. G

    Crusader 350

    OK, I think I’m finally onto something. I definitely don’t have enough voltage getting to the coil (under 4 volts)to fire it up. My question is where does the voltage come from to the resistor, does it come from the starter?
  6. G

    Crusader 350

    You might be onto something about the key switch. I took a quick peek under the dash and looks pretty old and crusty. I noticed the other one had been replaced. So I’ll pick one up today or tomorrow and in the meantime, take some measurements of voltage on cranking and at idle. What should I be...
  7. G

    Crusader 350

    Same as the starboard
  8. G

    Crusader 350

    1
  9. G

    Crusader 350

    OK was down at the boat and now the only way to get the engine started is to jump the external resistor. Did an ohms test on the resistor and coil everything checked out I’m getting spark at the coil even put a new coil in just to sure. Just wondering if anybody has any knowledge of these...
  10. G

    Crusader 350

    When I get down there later this afternoon, I’ll take some pictures and get serial numbers of the engines. What I was told the gentleman that had it prior to me had a bunch of work done on the boat. Engines, transmissions, new shafts, Rutters props, fuel tanks, unfortunately for him, he didn’t...
  11. G

    Crusader 350

    I will have to check later today when I get back down there, but I know there’s two on the negative side of the coil and I’m not sure if the Mallory was factory installed. I just purchased the boat the end of last year, they were new engines in 2017/18.
  12. G

    Crusader 350

    OK, having a problem with Crusader 350. Over the weekend went out fishing. Both engines started up no problem got to the fishing grounds, which is about half hour of run time. While drifting with the engines in neutral the port engine shut down and would not start until it cooled down. The...
See more
Back
Top