Logo
FULL SITE MENU

Recent content by greggwag

  1. G

    Honda 9.9 Extra Long Shaft Lower Water Pump Housing Removal

    No worries. This is a 9.9, and the repair manual says nothing about removing the vertical shaft. All is well; I have to wait for a few parts, and back together it will go. I didn't bother trying to replace the shift shaft seal. I attempted to remove one of the pins, and it wasn't budging, so I...
  2. G

    Honda 9.9 Extra Long Shaft Lower Water Pump Housing Removal

    Well, The whole gear case is apart, and the culprit is a step in the drive shaft. The shaft at the needle bearing in the housing is a smaller diameter than the shaft at the seals above. Only way to remove the housing is to remove the pinion gear on the end of the drive shaft, then the whole...
  3. G

    Honda 9.9 Extra Long Shaft Lower Water Pump Housing Removal

    I will do as you suggest though.
  4. G

    Honda 9.9 Extra Long Shaft Lower Water Pump Housing Removal

    The resistance is a hard stop, not spring-like.
  5. G

    Honda 9.9 Extra Long Shaft Lower Water Pump Housing Removal

    Here's what it looks like. That is as far as I can raise the housing.
  6. G

    Honda 9.9 Extra Long Shaft Lower Water Pump Housing Removal

    I don't think that's what's keeping the housing from coming off the drive shaft. I know the pin you are talking about though.
  7. G

    Honda 9.9 Extra Long Shaft Lower Water Pump Housing Removal

    Yes, that is removed.
  8. G

    Honda 9.9 Extra Long Shaft Lower Water Pump Housing Removal

    I was planning on replacing the drive shaft, and shift shaft seals on the lower water pump housing of my Honda 9.9, but when sliding the housing up the shaft, it hits a stop and won't go any further. It goes up about 1/2". The manual says that it should just come off, but something is preventing...
See more
Back
Top