Logo
FULL SITE MENU

Recent content by falgranado

  1. F

    J115PLEEM 1999 Jhonson 115 wont go over 2.5k RPM

    First of all Thanks for your reply! Yes, the muffs were over the intake, take 'em off after about 5 minutes (once I was out of the no-wake zone). No RPM drop. I got 3 beeps a couple times, but that's it. I haven't checked the starboard temp sensor; is that the brown wire, and do I test it...
  2. F

    1999 Johnson 115 in S.L.O.W mode

    Hi! Last Friday I was looking forward to enjoy some time on the water. While going at idle speed, I didnt notice anything abnormal on the engine's behavior , however when exiting the no wake zone, I went to WOT , but the engine would not go over 2500 RPM. I check to see if they were no...
  3. F

    J115PLEEM 1999 Jhonson 115 wont go over 2.5k RPM

    Good evening! I made a rookie mistake and left the muffs on the motor and ran about 5 minutes before realising. Removed the muffs and tried to continue my journey, however the motor wont go past 2.5k RPMs, at full throttle , I assumed the motor got hot since the it didn't have the normal water...
  4. F

    1999 115 Johnson Trim/Tilt working Intermittently

    Thank you all! I will be update once relays arrive and are installed
  5. F

    1999 115 Johnson Trim/Tilt working Intermittently

    Good Morning! Yesterday I was able to mount the trim/tilt unit back on and noticed that it wont raise when having load, I checked the fluid level and added more fluid (note : the fluid was milky/pink). What can I check next, I am a little lost. Any help would be appreciated. Regards
  6. F

    1999 115 Johnson Trim/Tilt working Intermittently

    I did a quick resistance test and both of them are between 77.2 ohms.
  7. F

    1999 115 Johnson Trim/Tilt working Intermittently

    Hello again! I just rebuilt the trim motor and its working perfectly fine connected directly to the battery, however when connecting to the Trim/tilt system, it doesnt activate. Im considering @makomark possibility of the relays. How can I test if the relay is working? I have a DMM on hand...
  8. F

    1999 115 Johnson Trim/Tilt working Intermittently

    I think I just found the issue. It seems that the cables on the motor are open and expose, possibly creating a short. I will remove the trim/tilt unit to confirm.
  9. F

    1999 115 Johnson Trim/Tilt working Intermittently

    Good morning! I am currently having issues with my tilt and trim. As the title says , when pressing down/up on the trim/tilt , sometimes works or sometimes it does not, leaving me to pull/push the engine up and down for maintenance and repairs. A couple of things that I have noted: The...
  10. F

    Trim gets stuck when all the way up

    Good evening fellow boaters! I was trying to do regular maintenance on my 1999 Jhonson 115 and during the removal of the lower unit process I trimmed all the way up, however during this process When I finished removing the lower unit , I tried trimming all the way down, but it would do...
  11. F

    Suspected VRO issue (J115PLEEM )

    Thanks for the insight!
  12. F

    Suspected VRO issue (J115PLEEM )

    Thank you! I will try to get it fixed this weekend and will let you know the results ! Also Would you happen to know the sitting tourque spec recommended by Johnson ?
  13. F

    Suspected VRO issue (J115PLEEM )

    Please see the image attached. I'm currently waiting for the gasket to get home, to replace and clean as recommended by racerone. But for a little more insight and maybe more feedback,see image attached. Please see video : J155PLEEM Fuel leak video
  14. F

    Suspected VRO issue (J115PLEEM )

    THank you for the references a direction I can go to, also providing reference to the diagrams. Based on the diagram, it seems to be leaking from component 27, please see attached picture. I will be going to the storage later today to provide a picture and a possibly a video of the leak, I wont...
  15. F

    Suspected VRO issue (J115PLEEM )

    Yes
See more
Back
Top