Logo
FULL SITE MENU

Recent content by Devonne

  1. D

    Mercury 115 4cylinder 2stroke 199*

    Ok a bare wire seems more like it because when we where running it would be on and off constantly and then towards the end it was pretty much all the time so would kinds seem like a wire rubbing, thanks, I'll dig into it
  2. D

    Mercury 115 4cylinder 2stroke 199*

    Hey guys so I got this mercury 115 4cylinder 2stroke here that the temp alarm just beeps, I tested it by following the single wire from the head to place that appears to be a ground I believe, when I pull it off alarm stops, so I ordered a kit to replace temp sensor, it came with gasket, sensor...
  3. D

    Alarm Sounding Oil or Temp Alarm

    So I have a mercury 115 and beeper goes constant when turning on key, I located temp sensor wire where it comes off the head and goes to a ground, so I took the wire off and it stops, so I ordered a new sensor and gasket and put the new one in and same beep, now in the kit I got there was a...
  4. D

    1995 evinrude E150JLEDB

    They did do compression test before doing carbs
  5. D

    1995 evinrude E150JLEDB

    I definitely won't be going back to that shop but they told me compression is ok at 70 which it runs perfect up to a 3500 rpm just a tiny bit more it promptly dies, so wouldn't seem like compression
  6. D

    1995 evinrude E150JLEDB

    Also can someone tell me what fuel pressure it should run, I put an inline fuel gauge and it was running between 2.5-3 at an idle
  7. D

    1995 evinrude E150JLEDB

    So he pretty much told me you start at the carbs and work from there so I told him go for it and he obviously gets all oem parts, he also replaced bowls because they were warped and he's said jets where missing so installed new ones, which made sense it drank gas before but now when u have it at...
  8. D

    1995 evinrude E150JLEDB

    Hello so I need help with my evinrude, I just bought the motor put it on my boat and went out and it ran ok but I couldn't give it more than half throttle, or it would just bog out and die, so had shop spend 2600$ on rebuilding all the carbs and I took it out and it's worse, it runs perfect up...
See more
Back
Top