I took my 270 outdrive in for service after noticing milky water mixed oil dripping from a small leak in my universal bellows. They replaced the bellows and u-joints and o rings and seals. When I picked it up I noticed some oil had dripped down the side of the upper unit. The mechanic...
"Hints and suggestions on gett
"Hints and suggestions on getting some of the play out of my steering that I notice a low speeds. How much tolorance is normal. When you move the outdrive by hand,their is a little play.How hard is it to replace bushings of bearings that might be involved. Where...
"My beloved Explorer has be ru
"My beloved Explorer has be running great and has taken me out over the Grays Harbor Bar and back many times safely. I do know that the boat is underpowered a bit, it was made back in the last gas crunch,and is stingy on fuel. I'm starting to plan on the direction...
"Took a cruise yesterday for t
"Took a cruise yesterday for the 2nd time out this season. Engine seemed to run fine. Had recently converted my distributor to electronic ignition. Fine tuned the timing a little bit under way, so it would not ping under acceleration with a heavy load. Everything...
"Thanks to everyone here for t
"Thanks to everyone here for the tips and advice on troubleshooting my aq125a/270 overheat problem.
It turned out to be the intake fitting on my 270. Now runs at 200F at planning speeds. Still weeps a little antifreeze, maybe a tablespoon over a few hour...