Logo
FULL SITE MENU

Recent content by catfishguru

  1. C

    Outboard been in storage for 4 years, what do I need to do before starting it?

    I bought a boat yesterday that has been in storage for the past 4 years. What should I do to get it ready to run? It was running when it was put in storage but I don't know about now. It is a 1990 Evinrude 40 HP with oil injection. Do I just put fresh gas and see if it will run? How do I...
  2. C

    1993 48 SPL tilt and trim seal replacement kit?

    I have searched and searched and cannot find a seal kit for this motor. It is a model E48ESLETE. I called a couple of dealers and they both told me I would have to buy the entire ram assembly for it. I just have a hard time believing I cannot find a seal kit to fix this thing rather than...
  3. C

    1991 40 Evinrude Lower unit problems

    "I have a 1991 40 hp Evinrude "I have a 1991 40 hp Evinrude that has lower unit problems. I was using the boat last weekend when I apparently hit a stump with the prop and the lower unit seized. I pulled the lower unit off the motor and disassembled it. What I found was that the clutch...
  4. C

    Bass Tracker Tournament 17 w 48SPLcavitating

    "I recently installed a 1993 E "I recently installed a 1993 Evinrude 48spl motor on a 1991 Bass Tracker Tournament TX17 that I am rebuilding. I finally got a chance to take the boat to the lake this past weekend to try it out. The motor runs perfectly, but it seems to be cavitating when I...
  5. C

    1993 Johnson 48SPL wiring

    "Hello all! I recently bought "Hello all! I recently bought a 1991 Bass Tracker TX17 with no motor. I finally found a 1993 Johnson 48 SPL to go on the boat but I have one question. On the motor there are two wiring harnesses. A large red one and then a small one with 5 wires. The boat already...
See more
Back
Top