Logo
FULL SITE MENU

Recent content by Bpos

  1. B

    fuel lines

    Wire ties or hose clamps for securing fuel lines?
  2. B

    1986 Classic 50

    First of all thanks to all those that helped me on this forum. Secondly when you get trash in your eye, use something eye appropriate, not carb cleaner. Less burning I'll guarantee ya. Who knew you could place the fuel pump gaskets in the wrong order even though they're shaped to fit one way...
  3. B

    1986 Classic 50

    After priming, Walbro carbs run good on fast idle, only to die after a few seconds. No low idle and I have to reprime the bubble in order to crank. Carbs are adjusted at 1 and1/2 turns. I've tried less but not more. How do you know if air might be getting sucked in to the system? No leaks...
  4. B

    1986 Classic 50

    When a starter solenoid is going bad can it work intermittently or will it just quit? Could the key switch go bad internally? I can jump across the solenoid and the motor spins. I can bench test the solenoid and it works. Just trying to narrow down the problem before changing parts. Thanks for...
  5. B

    Classic 50

    Carbs rebuilt. No leaks. Primer bulb won't stay hard. Anyone?
  6. B

    No giddy up

    1986 Classic 50. Been sitting seven years. Lower unit rebuilt. Whether water hose or lake, when in gear, one speed only..slow. RPMs don't advance. Hub not slipping. When I return to neutral, she shuts off and is difficult to crank. Haven't cleaned the carbs yet because after letting the motor...
  7. B

    Classic 50

    Lower unit replaced on 1986 Merc Classic 50. Engages into gear fine but when you pour the coal to it, it remains in idle speed. No advance in rpms and when you return to neutral, it shuts off and is hard to crank. Carb issues? It has two of them. Thanks for any help
  8. B

    Classic 50

    Brand new here. Lower unit rebuilt on a 1986 Classic 50 and I'm having trouble sliding her back in. Need help thanks.
  9. B

    Classic 50

    I have a 1986 Classic 50. After having the lower unit rebuilt I am unable to slide it back on. I get within about an inch or more and seems like something is hitting. The shift lever is short with splines but it stops short of lining it up. Help.
See more
Back
Top